DFI-ITOX G5G100-P User Manual page 81

Serial Port 1 Mode
COM 1 functions as a serial port or IrDA. You cannot use both at
the same time.
Normal
IrDA
IRDA Duplex Mode
Half Data is completely transmitted before receiving data.
Full Transmits and receives data simultaneously.
Onboard Serial Port 1 and Onboard Serial Port 2
Auto The system will automatically select an I/O address for
the onboard serial port 1 and serial port 2.
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3 Allows you to manu-
ally select an I/O address for the onboard serial port 1
and serial port 2.
Disabled Disables the onboard serial port 1 and/or serial port 2.
Onboard Serial Port 3
This is used to select an I/O address for the onboard serial port 3.
However, if the LCD Display Panel supports touch screen,
field in its default setting because the touch screen is internally
connected to COM 3 therefore a default address has already been
assigned to this port. Make sure COM 3 is not attached with a
serial device.
Onboard Serial Port 4
This is used to select an I/O address for the onboard serial port 4.
Serial Port 1 Use IRQ, Serial Port 2 Use IRQ, Serial Port 3 Use IRQ
and Serial Port 4 Use IRQ
These fields are used to select an IRQ for the onboard serial port 1,
2, 3 or 4.
This option sets COM 1 as serial port.
This option sets COM 1 as IrDA.
3
BIOS Setup
leave this
81