DFI-ITOX G5G100-P User Manual page 42

2
Hardware Installation
• Line-out (Lime)
In a 2-channel mode, this jack is used to connect a headphone
or external speakers. In a 4-channel or 6-channel mode, this jack
functions as front right/left speaker out.
Front Audio
The front audio connector (J2) allows you to connect to the line-out
and mic-in jacks that are at the front panel of your system. Using the
line-out and mic-in jacks will disable the rear audio's line-out and mic-
in functions.
Remove the jumper caps from pins 5-6 and pins 9-10 of J2 prior to
connecting the front audio cable connector. Make sure pin 1 of the
cable connector is aligned with pin 1 of J2. If you are not using this
connector, make sure to replace the jumper caps back to their
original pin locations.
Driver Installation
Install the "Audio Drivers". Refer to chapter 4 for more information.
42
2-channel
Light Blue Line-in
Lime Line-out
Pink Mic-in
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open
4-channel 6-channel
Rear R/L
Rear R/L
Front R/L
Front R/L
Mic-in Center/Subwoofer
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.