Advertisement
2 | PVA-1EB Call station emergency button
3.
Carefully remove the baseplate from the upper part,
start on the top left corner of the call station.
4.
Unplug the connecting cable from the CN1 plug
connector ➋.
5.
Prepare installation location ➌: Use a sharp object
(scriber or similar) to carefully punch through and cut
out the pre-cut rectangle on the inside of the housing.
Perform any follow-up work that may be required to
the installation location (e.g. filing, trimming).
6.
Mount the button into the installation location, and
press in evenly (it must be possible for the cover cap
to open upward).
7.
Depending on whether the right/middle/left
installation location is used, plug the ribbon cable ➍
into plug connector CN201/CN202/CN203 on the
circuit board.
8.
Plug the connecting cable into CN1 again.
9.
Carefully re-attach the call station baseplate.
10. Re-connect the connections.
11. Configure the button using the software.
3
2
Parts included
Quan
Component
tity
1
Button element with cover
1
Preconfigured 4-pin connecting cable
1
Installation note
1
Advertisement
