Daewoo DALMCH18-1 User Manual page 8

5. OPERATING INSTRUCTIONS
Please wear suitable clothing and work gloves when using this parent. Before each use, make sure
the belt is running normally. start/off switch and safety switch must be available for normal
use.When loosening the start switch, the power must be turned off. If the switch is damaged, stop
using the device Make sure the voltage of the power supply is consistent with the voltage on
the nameplate. The risk of injury can be reduced by wearing protective devices and ensuring that
the devices are functioning properly.
Confirm the frequency of the operation to ensure that the operation is in the best condition.
• In order to save the use of electric batteries and ensure the best service life of pruning and shea-
ring, do not allow this load of overloaded lice to cut wet and dry branches over 60mm diameter and
20mm.
• When cutting the knife edge mode to stop the operation, turn off the power switch and splash
down the battery box.
Skills
1) When the device is running, say your other hand is at least 15cm away from the cutting area of the
blade, and the hand must not be put into the knife edge.
2) Do not use this equipment to force the bigger branches, otherwise it may make the blade deform
and make the pruning stick.
4) In cold or humid weather, to protect the battery pack, put it under waterproof clothing, do not use
this equipment in rainy days.
5) We recommend that after daily use, the connection between the pruning number and the battery
pack must be cut, and the power switch (8) is closed and put together into the matching tool box.
6) If the user feels the electricity is not enough or the cutting is not smooth enough, check if the
electricity is exhausted or the blade is dull
Cleaning and maintenance
Repair functions not mentioned herein shall be performed by the Service Centre. To ensure the
safety of use, only the original parts can be used.
Repair work functions not mentioned in this specification are performed by the service center. To
ensure safe use, only original parts can be used.
Please close the equipment before starting the chair repair. Clear the connection between the
battery and the plant and store the battery in a safe package.
Wear hand care when touching safety blades. This can avoid sharp blade scratching the user.
Follow-up cleaning and maintenance must be carried out regularly. This ensures long-term and
reliable operation of the equipment.
Clearness
Do not spray the equipment with water or break it into the water, otherwise, it may cause electric shock.
Keep the ventilator, motor room and equipment handle clean. Use a damp cloth or brush cleaner.
Do not use a bay cleaner. Otherwise, it may cause permanent saka failure of the equipment. Please
clean the blade carefully after each use.
Use oily cloth to wipe the blade and absorb the metal to protect the fog.
After 8 hours of continuous operation, please remove the debris such as dust from the front turbu-
lent cover plate of the equipment
8