Daewoo DALMCH18-1 User Manual page 7

EN
• Before charging, check that the surface of the battery is clean and dry.
• Before delivery, the battery of this product is not fully charged. Therefore, before the first use, it
must be sufficient electricity.
• Do not charge the battery for long periods of time, and do not run out of all the power in the soap
tank, otherwise it will damage the battery.
• The Essential Security Department does not include failure due to incorrect use.
• If the battery with sufficient electricity is significantly shorter, it must be replaced if the battery is
exhausted.
• The user can only use the battery pack manufactured by the original equipment operated by the
customer center.
Always keep in mind applicable safety instructions and protection requirements and
environmental information
1) Put the charger in the room between +10 and +22M, and stops moisture entering.
2) Check that the switch is in off position.
3) Connect the charger to the corresponding connector for the battery pack.
4) Make sure the power is consistent with the rated values on the charger and adapter.
5) When the red light is on the charger, it indicates that the battery is charging, and the green light
indicates that the charge is completed. The average charge time is 2 hours.
6) When charging is complete, drive the connector from the power source and then cut off the
connector and battery connection.
7) The battery is used to ensure that it is recharged at least once every three months.
Maintain charging temperature 0-C-45-C for soap charger and battery pack, discharge temperature
-1-CTC for battery pack ~60°C
7