Table of Contents
Advertisement
Installation
Installing several
SmartLine elements
The gaps between the individual
SmartLine elements are sealed with a
silicone sealant that is heat-resistant to
at least 160 °C. With flush-fit
installation, the gap between the
SmartLine element(s) and the worktop
must also be sealed with a silicone
sealant that is heat-resistant to at least
160 °C.
After installation, the SmartLine
elements must be easily accessible
from below, so that the bottom half of
the casing can be removed for
maintenance. If the SmartLine elements
are not accessible from below, the
sealant must be removed so that they
can be removed.
Combination with a downdraft
extractor
If the SmartLine element is installed in
combination with a downdraft extractor,
the latter must be installed first.
Induction wok next to the downdraft
extractor
The induction wok can only be fitted on
the side of the downdraft extractor
opposite the connector.
63
Advertisement
Table of Contents
