Maintenance; Vacuum Cleaner Storage; Replacing The Dust Bag - Simplicity Scout Plus Owner's Manual

MAINTENANCE

Vacuum Cleaner Storage

When not in use, ensure that the cleaner
is disconnected from the power supply
and that the cable is fully retracted. The
combination floor tool can be stored in
the floor tool holders. Other floor tools
must be stored separately.

Replacing the Dust Bag

IMPORTANT! Ensure that the cleaner
is disconnected from the power supply
when installing or removing the dust bag.
Note: Only use the dust bag supplied
or recommend by the manufacturer to
avoid causing damage to the machine
and voiding the warranty.
(Fig 18)
Always operate the cleaner with the
dust bag installed. If you forget to install
the dust bag or the dust bag is installed
incorrectly, the dust bag cover may not
close completely.
• Remove the hose from the air inlet.
• Open the cover by pulling on the Dust
Bag Cover Latch.
• To stop dust and debris from escaping
when removing the dust bag from the
machine, firmly hold the dust bag in
the dust bag holder and gently pull the
dust bag seal.
• Refit a new dust bag by inserting
the dust bag collar into the dust bag
bracket. Ensure that the arrow on the
dust bag collar is facing downwards
13
(Fig 18)