Cabling; Cabling Guidelines - Hitachi HA820 G2 User Manual

Cabling

Cabling guidelines

The cable colors in the cabling diagrams used in this chapter are for illustration purposes only. Observe
the following guidelines when working with server cables.
Before connecting cables
• Note the port labels on the PCA components. Not all these components are used by all servers:
System board ports
◦
Drive and power supply backplane ports
◦
◦ Expansion board ports (controllers, adapters, expanders, risers, and similar boards)
• Note the label near each cable connector. This label indicates the destination port for the cable
connector.
• Some data cables are prebent. Do not unbend or manipulate the cables.
• To prevent mechanical damage or depositing oil that is present on your hands, and other
contamination, do not touch the ends of the connectors.
When connecting cables
• Before connecting a cable to a port, lay the cable in place to verify the length of the cable.
• Use the internal cable management features to properly route and secure the cables.
• When routing cables, be sure that the cables are not in a position where they can be pinched or
crimped.
• Avoid tight bend radii to prevent damaging the internal wires of a power cord or a server cable.
Never bend power cords and server cables tight enough to cause a crease in the sheathing.
• Make sure that the excess length of cables is properly secured to avoid excess bends,
interference issues, and airflow restriction.
• To prevent component damage and potential signal interference, make sure that all cables are in
their appropriate routing position before installing a new component and before closing up the
server after hardware installation/ maintenance.
Hitachi Advanced Server HA820 G2 User Guide 144