Hitachi HA820 G2 User Manual page 139

To place the server in standby mode, press the Power On/Standby button. When the
b
server enters standby power mode, the system power LED changes to amber.
Disconnect the power cords (rack and tower servers).
c
4. Do one of the following:
Depending on your product, extend or remove the server from the rack.
•
Remove the server from the enclosure.
•
5. If removed, place the server on a flat, level work surface.
6. Remove the access panel.
7. Remove any options or cables that might prevent access to the TPM connector.
8. Proceed to "Installing the TPM board and cover."
Installing the TPM board and cover
Procedure
1. Observe the following alerts:
CAUTION: If the TPM is removed from the original server and powered up on a different server, data stored in the TPM
including keys will be erased.
CAUTION: The TPM is keyed to install only in the orientation shown. Any attempt to install the TPM in a different
orientation might result in damage to the TPM or system board.
2. Install the TPM board:
a. Locate the TPM connector on the system board. See the server hood label for the exact
location.
b. Align the TPM board with the key on the connector, and then install the TPM board. To seat
the board, press the TPM board firmly into the connector.
Hitachi Advanced Server HA820 G2 User Guide 139