Table of Contents
Advertisement
Run silicone sealant around the entire contour of the intercom panel, on a dry wall to
prevent moisture staying on the wall.
8 – Insert the screws and refit the two caps concealing the retaining screws.
Note:
screw through the black covers on the back of the intercom panel without removing
them.
Make sure the rubber sheet stays on the intercom panel.
9 – Refit the front cover of the intercom and tighten the tamper-resistant retaining screw.
10 - Connect the 230V AC power supply to the modular adaptor, for an installation compliant
with applicable standards (NFC 15-100 in France).
- Verify the smooth functioning (video call, RFID, etc.).
- When there is a second intercom panel, don't forget to configure the monitor(s).
11 - Attach a silicone seal* between the shield and the wall to stop flowing water. *Do not
use acetic acid-based silicone (vinegar odour).
5. Installing a camera (optional)
Connect the wires in accordance with the wiring diagram.
Choose a suitable place to install the camera.
Ensure that nothing gets in the way of the installation.
Screw the wall section with the screws provided (for solid walls).
Point the camera in the desired direction and tighten the retainer screw.
Configure the monitor(s)
6. MONITOR INTERFACE
Main menu
Lightly touch the screen to turn it on and access the main menu
23:59 01/07/2017
23:59 01/07/2017
A
A. Monitoring function
B. Intercom function
C. Settings
D. Photo album
E. Video album
GB9
On
B
C
WelcomeEye Connect Pro / V5
FULL
FULL
MEM.
MEM.
22
4
D
E
On
Advertisement
Table of Contents
