Table of Contents
Advertisement
Warning:
during this step, do not connect the power supply to the 230V AC.
4. Installation of the main or additional intercom panel
Warning:
The product must not be connected to the power supply before the wiring has
been completed.
1
4
5
3
1
0
2
2
1
2
1
2
1 2 3 4
5 6
7 8
1
2
SMARTHOME FRANCE
5
3
1
0
2
2
19 avenue Marcel Dassault 37200 TOURS
FRANCE
20V
110mA
RFID 125kHz
IP44
7
1 - Remove the tamper-resistant screw from underneath the intercom panel, using the key
provided.
2 - Tip the intercom panel cover forward.
3 – The intercom's lens should be approximately 1.60m above the ground.
4 – Mark the locations.
5 - Drill.
6 - Use pegs adapted to the nature of the support (the screws supplied are suitable for
solid walls).
7 – Connect the two wires from the monitor and, if necessary, connect the electric strike
plate and the gate (see section 1. Wiring). Configure the switches at the back of the
intercom panel (see section 2. Configuring the intercom).
2
5
2
1
1
2
8
WelcomeEye Connect Pro / V5
*
1m60
3
6
9
GB8
Advertisement
Table of Contents
