Installing A Camera (Optional); Monitor Interface - Philips WelcomeEye Touch Instructions For Using Manual

5 - Drill.
6 - Use pegs adapted to the nature of the support (the screws supplied are suitable for
solid walls).
7 – Connect the two wires from the monitor and, if necessary, connect the electric strike
plate and the gate (see section 1. Wiring). Configure the switches at the back of the
intercom panel (see section 2. Configuring the intercom).
8 – Insert the screws and refit the two caps concealing the retaining screws.
Note: screw through the black covers on the back of the intercom panel without removing
them.
9 – Refit the front cover of the intercom and tighten the tamper-resistant retaining screw.
10 - Connect the 230V AC power supply to the modular adaptor, for an installation compliant
with applicable standards (NFC 15-100 in France).
- Verify the smooth functioning (video call, RFID, etc.).
- When there is a second intercom panel, don't forget to configure the monitor(s).
11 - apply a silicone seal around the intercom panel to prevent any penetration of water.

5. Installing a camera (optional)

Connect the wires in accordance with the wiring diagram.
Choose a suitable place to install the camera.
Ensure that nothing gets in the way of the installation.
Screw the wall section with the screws provided (for solid walls).
Point the camera in the desired direction and tighten the retainer screw.
Configure the monitor(s)

6. MONITOR INTERFACE

Main menu
Lightly touch the screen to turn it on and access the main menu
23:59 01/07/2017 23:59 01/07/2017
A B
A. Monitoring function
B. Intercom function
C. Settings
D. Photo album
E. Video album
On
22
C D
WelcomeEye Connect 2 / Touch / V4
FULL FULL
MEM. MEM.
4
E
On
F9