Table of Contents
Advertisement
RP-1 Remote Control Processor
POWER SENSE INPUT DOES NOT FUNCTION PROPERLY
Verify that the proper conditional statement is used in
!
the TheaterTouch Designer™ software.
!
Make sure you are using a known good IR emitter, and
it is attached to the correct location on the device being
controlled.
RP-1 USB PROGRAMMING PORT DOES NOT WORK
Verify that your PC is using Windows 2000
!
The TheaterTouch Designer software requires a USB
device driver that may not be installed on earlier
versions of Windows.
Make sure you are using the programming cable that
!
was supplied by RTI and that both ends are connected
securely.
Make sure the PC detects the presence of the T2+. If it
!
doesn't, unplug the USB cable, wait for about ten
seconds, and plug it in again.
!
If the download fails after some data has been
transferred, try re-sending the program.
14
®
or higher.
Advertisement
Table of Contents
