Related Manuals for RTI ZRP-6
Summary of Contents for RTI ZRP-6
- Page 1 It’s Under Control ® It’s Under Control ® ZRP-6 Remote Control Processor 70-20058-23 V....
- Page 2 ZRP-6 Remote Control Processor Copyright © 200 Remote Technologies Incorporated All rights reserved.
-
Page 3: Federal Communications Commission Notice
This device may not cause harmful interference. This device must accept any interference received including interference that may cause undesired operation. 117 612 914 deClaRatIOn OF COnFORmItY (dOC) The Declaration of Conformity for this product can be found on the RTI website at: www.rticorp.com/declaration... -
Page 4: Safety Suggestions
ZRP-6 Remote Control Processor saFetY suGGestIOns Read Instructions. Read all safety and operating instructions before operating the unit. Retain Instructions. Keep the safety and operating instructions for future reference. Heed Warnings. Adhere to all warnings on the unit and in the operating instructions. -
Page 5: Limited Warranty
Remote Technologies Incorporated’s liability for any defective product is limited to repair or replacement of the product, at our option. If your ZRP-6 Remote Control Processor needs service, please contact Remote Technologies Incorporated by telephone, fax or E-mail for return information. -
Page 6: Disclaimer
Microsoft Corporation in the United States and other countries. ZigBee is a registered trademark of the ZigBee Alliance. ZRP-6, Integration Designer, and the RTI logo are registered trademarks of Remote Technologies Incorporated. Other brands and their products are trademarks or registered trademarks of... -
Page 7: Table Of Contents
It’s Under Control ® table OF COntents Federal Communications Commission notice ....3 safety suggestions ............4 limited Warranty ............5 disclaimer ..............6 Contents ..............7 Chapter 1 - Welcome ........... 9 Important Notes ............9 Product Contents, Unpacking ........0 Chapter 2 - Features ........... - Page 8 ZRP-6 Remote Control Processor...
-
Page 9: Chapter 1 - Welcome
Avoid installing the ZRP-6 in a location where it can come in contact with direct sunlight. Do not let the ZRP-6 get wet. It should not be handled with wet hands or placed in an area where it could get wet. - Page 10 • Two (2) RS-232 adapters unPaCKInG and InsPeCtIOn After unpacking your new ZRP-6 Remote Control Processor, save all of the packing materials in case you ever have to ship the unit. Thoroughly inspect the ZRP-6 and packing materials for signs of damage.
-
Page 11: Chapter 2 - Features
It’s Under Control ® CHaPteR 2 | FeatuRes The ZRP-6 provides superior quality and reliability as well as these specific features: Six multi-purpose I/O ports. Three programmable 2VDC trigger outputs. Three assignable voltage sense inputs. Three programmable relay outputs. Two RS-232 ports for bi-directional communication. - Page 12 ZRP-6 Remote Control Processor CHaPteR 2 | FeatuRes Status Light Ethernet Ethernet Link Indicator RTI COM Port IR Output Adjustment Controls Expansion Port RS232 MPIO Ports Power (IR, CM232, VPS-/SPS-) Supply Relays DC Sense DC Trigger Power/IR...
-
Page 13: Chapter 3 - Installation And Operation
POWeR The included AC adapter should be connected to the POWER jack on the ZRP-6. The power LED will turn-on and the output LEDs will toggle on and off in sequence to confirm that the unit is running properly. Use only the supplied AC adapter to power the ZRP-6. Using a different power supply could result in damage to the ZRP-6 or poor performance. - Page 14 The IR output gain can be separately adjusted for each of the six output ports. The ZRP-6 is shipped with the IR gain set to the optimum level for most equipment, and it should only need to be adjusted if the attached equipment is not responding reliably.
- Page 15 ® IMPORTANT NOTE: Baud rate 5,200bps is not supported using the CM-232 module with the ZRP-6. You must use one of the two dedicated RS-232 ports if this baud rate is required. VOltaGe tRIGGeR OutPut...
- Page 16 (RS-85) with in-wall touchpanels or expansion devices. Rs-232 PORts The ZRP-6 is capable of two-way RS-232 communication and uses industry standard cat5 cable with RJ-5 termination (568B). NOTE: RS-232 communication has a distance limitation of 50-00 feet.
- Page 17 (i.e. the ZRP-6 programming does not match the programming in the device that is transmitting the trigger code), or if the system zone code does not match. The status LED will illuminate Red if the ZRP-6 does not contain a valid program.
- Page 18 CHaPteR 3 | InstallatIOn and OPeRatIOn COnneCtIOn OPtIOns RTI Connecting ZigBee ® Block (CB-8) The following diagram illustrates some Module of the ZRP-6 connection options. (ZM-2) Each IR output can Power drive up to four Supply emitters directly. More than four...
- Page 19 It’s Under Control ® CHaPteR 3 | InstallatIOn and OPeRatIOn COnneCtIOn OPtIOns (COntInued) ZRP-6 connection examples: RS-232 Control (cat5) Adapter Lighting Relay Control Drapes Voltage Sense Input Receiver Voltage Trigger Output Screen Lift Optional accessories shown are sold separately.
- Page 20 ZRP-6 Remote Control Processor...
-
Page 21: Chapter 4 - Specifications
Two, Bi-directional RJ5 Connections Ethernet Port 0/00Base-T, RJ5 Connection USB Ports Type B Programming Expansion Port RS-85 / IR / Pwr, RJ5 Connection RTI Com Port Two-way ZigBee Communication Port, RJ5 ® Connection Relays Three, 5 Amps @ 30 VDC Max... - Page 22 ZRP-6 Remote Control Processor...
-
Page 23: Chapter 5 - Troubleshooting
Try re-programming both the ZRP-6 and the remote control to make sure the programming is up-to-date (i.e.“in sync”) in each of them. Make sure the IR or RF receiver wire is attached to the ZRP-6 properly. Make sure the IR or RF receiver is mounted away from strong electro- magnetic energy sources. - Page 24 ZRP-6 Remote Control Processor...
-
Page 25: Chapter 6 - Service And Support
Fax (952) 253-33 info@rticorp.com RtI teCHnICal suPPORt At RTI, customer service and satisfaction is an utmost priority. If you are encountering any problems or have a question about your RTI product, please contact RTI Technical Support for assistance. RTI provides technical support by telephone, fax or e-mail. For the highest quality service, please have the following information ready, or provide it in your fax or e-mail. - Page 26 ZRP-6 for service RTI will pay all labor and material expenses for all repairs covered by this product’s warranty. If necessary repairs are not covered by warranty, or if a unit is examined which is not in need of repair, you may be charged for the repairs or examination.
-
Page 27: Index
Mounting/Power ............3 Programming ..............7 Limited Warranty/Disclaimer ..........5 Product Contents .............. 0 Safety Suggestions ............. Service and Support ............25 Contact RTI ..............25 Shipment for Service ............. 26 Technical Support ............25 Specifications ..............2 Troubleshooting ..............23... - Page 28 ZRP-6 Remote Control Processor It’s Under Control ® Remote technologies Incorporated 5775 12th avenue east, suite 180 shakopee, mn 55379 tel: 952-253-3100 Fax: 952-253-3131 www.rticorp.com © 200 Remote Technologies Inc. All rights reserved. Printed in Taiwan.