To prepare the Meter for rack mounting, remove the bail and remove the front and rear
protective boots. To remove a boot, stretch a corner then slide it off as shown in Figure 2-
5.
To install the Meter into the rack, refer to the instructions provided with the Rack Mount
Kit.
Cleaning the Meter
To avoid electric shock or damage to the Meter, never get water
inside the Meter.
To avoid damaging the Meter's housing, do not apply solvents
to the Meter.
If the Meter requires cleaning, wipe it down with a cloth that is lightly dampened with
water or a mild detergent. Do not use aromatic hydrocarbons, alchohol, chlorinated
solvents, or methanol-based fluids when wiping down the Meter.
Fluke 45 Emulation
To switch the Meter to Fluke 45 emulation:
Press and hold Sand f for two seconds.
Figure 2-5. Boot Removal
XW Warning
W Caution
Preparing the Meter for Operation
Cleaning the Meter
2
eue22.eps
2-9