Setting The Switches - Panasonic WV-CW864A Operating Instructions Manual

4. Setting the Switches

The 8-bit DIP switch has two functions. It is
used to restore the factory default settings
and to specify the unit number. Before set-
ting, peel off the seal covering the switch
holes. After setting the switch, replace the
seal. The 4-bit DIP switch selects termina-
tion ON/OFF and half/full duplex for RS485
communication.
read into the camera when the power is
turned on. After changing the switch set-
tings, be sure to turn the power off, then turn
it back on again. Switch positions and func-
tions are shown below.
RS485 Parameter Setup
The selected protocol, communication para-
meters, and set unit numbers are read into
the camera when the power is switched on.
(1) Switch off the camera.
(2) Set the switch as shown in the table
below.
(3) Set the unit number with the DIP switch
(see the next page).
(4) Switch on the camera to read in the
changed switch settings.
Note:
parameters are displayed on the
RS485 SETUP menu after the cam-
era has been switched on.
51
The switch settings are
The changed communication
Camera top view
Switch view
Switch position
Returns to the factory default settings.
ON
1 2 3 4 5 6 7 8
Parameter selection
Switch position
Baud rate
ON
19 200
1 2 3 4 5 6 7 8
ON
9 600
1 2 3 4 5 6 7 8
ON
4 800
1 2 3 4 5 6 7 8
Switch position
Multiplex-Coaxial communication
ON
1 2 3 4 5 6 7 8
REAR
Seal
Parity Stop
Data bit
check bit
8 None 1
8 None 1
8 None 1