Installer Compliance Responsibility - Ubiquiti airFiber AF-11 Quick Start Manual

AF11-Complete Quick Start Guide
Adjust the elevation angle:
a. Loosen the eight hex head bolts so that the washers can spin freely by hand.
b. Tighten or loosen the Elevation Adjustment Bolt to set the desired tilt.
c. Tighten the eight hex head bolts.
Note: Do NOT make simultaneous adjustments on the Master and Slave.
2. Slave Visually aim the Slave at the Master. To adjust the Slave's position, adjust the
azimuth and elevation as described in step 1.
3. Check to see if a link is established. Ensure that the LINK LED is solidly lit green and
the Signal LEDs of the Slave are displaying signal levels.
4. Slave Aim the Slave at the Master to achieve the strongest signal level on the
Master.
Note: Refer to the Signal LEDs section for details on the signal values.
Note: Maximum signal strength can best be achieved by iteratively sweeping
through both azimuth and elevation.
5. Master Aim the Master at the Slave to achieve the strongest signal level on the
Slave.
6. Repeat steps 4 and 5 until you achieve an optimal link, with all four Signal LEDs
solidly lit. This ensures the best possible data rate between the airFiber radios.
7. Lock the alignment on both airFiber antennas by tightening all the nuts and bolts.
8. Observe the Signal LEDs of each airFiber radio to ensure that the values remain
constant while tightening the nuts and bolts. If any LED value changes during the
locking process, loosen the nuts and bolts, finalize the alignment of each airFiber
antenna again, and retighten the nuts and bolts.
For detailed information on setting up an airFiber link, see the airFiber AF-11FX User
Guide available at: ui.com/download/airfiber

Installer Compliance Responsibility

Devices must be professionally installed and it is the professional installer's
responsibility to make sure the device is operated within local country regulatory
requirements.