Troubleshooting - Panasonic WJ-SX150 Operating Instructions Manual

TROUBLESHOOTING

Check to see the following before request for repair.
If a trouble cannot be removed even after checking and trying remedy, contact your dealer.
Problem
Matrix switcher does not power up.
System controller(s) do (does) not log
in.
Monitor is not selectable.
Camera image is not displayed even
after selecting the camera.
128
Check item
The power cord may be disconnected
either from the unit's power socket or
the AC outlet.
The unit's power cord may be discon-
nected from the AC outlet.
The cable connection(s) may be wrong
between the unit and the system con-
troller(s).
The mode selection switch setting of
the system controller may be wrong.
Data port setting may be wrong.
Your ID, user number or password may
be wrong.
The monitor selection setting may be
wrong.
The camera's power cord connection
may be wrong.
The cable connections may be wrong
between the unit and the camera.
The lens cover may not have been
removed from the camera.
The monitor's brightness or contrast
setting may not be proper.
Remedy
Connect the power cord between the
unit ' s power socket and the AC outlet.
Connect the power cord to the AC out-
let.
Confirm the cable connections. (Refer
to p. 40.)
Confirm the mode selection switch set-
ting. (Refer to p. 24.)
Open the Data Port window of WJ-
SX150 Administrator Console (refer to
p. 81.) to select CU360 for the data
port. If 485 CAM is selected for the port,
the log-in will be invalid.
Refer to your Operator Registration
worksheet. Or open the Operator Regis-
tration window (refer to p. 75) and
reconfigure your ID, user number and
password.
Open the Monitor Selection window
(refer to p. 76) and confirm the setting.
If NG is assigned to your controller for
the monitor, the selection will be invalid.
Confirm the power cord connection.
(Refer to the camera's operating
instructions.)
Confirm the connections (pp. 37 to 39).
If the connections and camera type are
not correspondent, the camera image
will not appear.
Remove the lens cover from the cam-
era.
Adjust the setting. (Refer to the moni-
tor's operating instructions.)