Changing To Black And White Images; Patrol Learn And Play - Panasonic WJ-SX150 Operating Instructions Manual

Changing to Black and White Images

This function gets the clear camera images on the monitor
while shooting the objects under low light conditions.
1. Select the desired monitor and camera. (Refer to p. 90
Monitor Selection and p. 91 Camera Selection.)
2. Press the AUTO PAN button two times while holding
down the SHIFT button.
"BLACK (black)" will appear on the LED display of the
controller as shown in the figure.
F1 ACK
CAM SETUP SUSPEND
F2 GROUP SEQ
INDEX REW/FF
PREV
STEP
RECORDER
STOP
STOP PLAY
OSD
SETUP
3. Press the button 1 to change the image from the color
mode to the black and white mode on the active moni-
tor.
"BL ON (BLACK ON)" appears on the LED display to
indicate the selected mode.
4. Press the button 2 to change the black and white image
to the color image on the active monitor.
"BL OF (BLACK OFF)" appears on the LED display to
indicate the selected mode.
5. Press the MON (ESC) button to exit from the mode.
Note: When the black and white parameter is set to
AUTO in the camera's SETUP MENU, this function
is disabled.
95
RESET
ALL RESET
CALL
TOUR SEQ PRESET
T&D CAM ID EVENT
AUX1 OFF AUX1 ON PROGRAM
STILL
PRESET
NEXT
MON STATUS ALL
AUTO PAN
AUX2 OFF AUX2 ON
EL-ZOOM
PAUSE
ALM H VLD H SYS S
CAM FUNC
DEF OFF DEF ON
PAUSE SEQUENCE
MON (ESC) CAM (SET)
CLEAR
LOG OUT
SHIFT MON LOCK WIPER
MULTI SCREEN SEL

Patrol Learn and Play

A routine of manual operations can be stored for a specific
time and later reproduced repetitively.
1. Select the desired monitor and camera. (Refer to p. 90
Monitor Selection and p. 91 Camera Selection.)
2. Press the AUTO PAN button three times while holding
down the SHIFT button.
"LEARN" will appear on the LED display of the controller
as shown in the figure.
F1 ACK RESET
CAM SETUP SUSPEND ALL RESET
F2 GROUP SEQ TOUR SEQ
INDEX REW/FF
PREV NEXT
RECORDER STEP
STOP PAUSE
STOP PLAY PAUSE
OSD
SETUP SHIFT
3. To save the patrol sequence, follow the procedure
below.
q Press the button 2, then press the CAM (SET) but-
ton.
"LE R" appears on the LED display.
w Operate the camera manually.
e Press the button 3.
The operation data is saved and "LE S" appears on
the LED display.
4. To reproduce the operation data, follow the procedure
below.
q Press the button 1.
"LE P" appears on the LED display.
w Press the button 3.
The reproduction is ended.
5. To exit from the mode, press the MON (ESC) button.
CALL
PRESET
T&D CAM ID EVENT
PROGRAM
STILL AUX1 OFF AUX1 ON
PRESET
MON STATUS ALL
AUTO PAN
AUX2 OFF AUX2 ON
EL-ZOOM
ALM H VLD H SYS S
CAM FUNC
DEF OFF DEF ON
SEQUENCE
MON (ESC) CAM (SET) CLEAR
MON LOCK WIPER LOG OUT
MULTI SCREEN SEL