System Status Table; Setup Procedures; Extended Functions - Panasonic WJ-SX150 Operating Instructions Manual

System Status Table

The current system status can be identified.
The continuous display becomes possible by the OSD set-
ting.
MON CAM
1 01
2 02
3 04
4 16
MON: Monitor's unit address number
CAM: Camera No.
MODE: Operation mode
KB: Controller's unit address number
OPE: Operator number
PRI: Priority

Setup Procedures

To use the unit, it is necessary to configure the system
through the following setup procedures:
• OSD setup with an active monitor and system controller
The basic parameters are configurable to operate the
unit.
• WJ-SX150 Administrator Console with the PC
The setup utility can configure all the functions of the
unit.
Refer to p. 52 WJ-SX150 SETUP MENU (OSD) and p. 64
WJ-SX150 ADMINISTRATOR CONSOLE for details.
19
SYSTEM STATUS
MODE KB OPE PRI
T01 K1 1 16
SPOT K2 2 2
ALARM K4 4 1
CAM PC 30 1

Extended Functions

If a recorder is connected to the matrix switcher, the follow-
ing will be available.
Recorder Connection
The time-lapse recording and playback of all the camera
images connected to the unit are possible.
Each camera's image and camera ID are recorded.
You can search and play back the desired camera's image
by the camera ID.
The time-lapse recording is conducted as following.
Start
Camera1 Camera 2 Camera 3
t t
The operations are conducted with the buttons on the
recorder, system controller or PC.
• The setup of the recording device
• The start of the playback
• The stop of the playback
• The playback of the recorded images (the multiscreen
display, still spot picture or still multiscreen picture,
etc.)
• The search for the recorded image (the search by the
camera ID, or the recorded time and date)
• Forward or backward search
• Forward of backward field advance
• Fast-forward
• Rewind
• Index
Refer to each device's operating instructions for details.
Camera 4 Camera 5