Table of Contents
Advertisement
2.1 Turning the Power On
If the unit has been off for at least five seconds, take the following steps to power it up.
1.
Slide up the power switch cover which is located on the left side of the monitor.
2.
Press the power button to start the POS computer.
3.
Slide the power switch cover back down to prevent accidentally pressing the power button.
If nothing is displayed on the screen for 10 seconds or more after the power
Note:
has turned on, verify the following:
• Is the standby LED lit (see page 5)? If not, the system is not receiving power.
• Is the power circuit active?
• Is the power cord connected to the outlet?
• Was the power turned back on within 5 seconds of being turned off?
(The power must be not turned back on until at least five seconds after the power
has been turned off.)
If the above checks reveal no abnormalities, contact your support department.
THIS DOCUMENT CONTAINS CONFIDENTIAL INFORMATION, IS PROVIDED FOR FUJITSU CUSTOMER USE ONLY,
AND IS NOT TO BE SHARED WITH ANY THIRD PARTY WITHOUT FUJITSU'S PRIOR WRITTEN CONSENT.
Basic Operations
2
Page 9
Advertisement
Table of Contents
Troubleshooting
