Handling Precautions - Fujitsu TeamPoS 7000 Series User Manual

Handling Precautions

Precautions while installing
The power cord may need to be unplugged from the unit if a fault occurs. Set up the unit in
a location where this can be done easily.
THIS DOCUMENT CONTAINS CONFIDENTIAL INFORMATION, IS PROVIDED FOR FUJITSU CUSTOMER USE ONLY,
AND IS NOT TO BE SHARED WITH ANY THIRD PARTY WITHOUT FUJITSU'S PRIOR WRITTEN CONSENT.
Be sure to comply with all power requirements. If the unit is used in a
location where the power requirements cannot be met, the unit must be
used with a constant voltage constant frequency (CVCF) unit.
Use a ground wire classified as type III (grounding resistance of 100
ohms or less) or better to ensure safety.
Do not put a clip or other similar object into an inter space of the
controller's rear cover.
Do not place the unit in a location exposed to direct sunshine or in a
location subject to high temperatures and humidity.
Do not place the unit in an adverse environment (locations subject to
large amounts of industrial gas, waste and dust).
Do not place the unit in a location subject to strong vibrations.
When a ground leakage circuit breaker is to be installed, select one
with a breaking current capacity to suit the system, and which is not
likely to respond to high frequencies.
Install lightning protection measures. The provision of a lightning
arrester is recommended in locations prone to electrical storms and
lightning.
Do not place the unit close to a source of electrical noise
Do not place the unit in a strong magnetic field
Place the unit in a location that is not prone to static electricity build-up.
Avoid reflections from room lights. The intensity and radios. of
illumination (400 to 600 lux), equivalent to the lighting level in a normal
office or store, is sufficient.
Always place the unit on a flat surface.
Hold the controller by the side edges whenever you lift it up.
Preface - vi