Fujitsu TeamPoS 7000 Series User Manual page 46

3. Rolling the paper
The paper must be rolled uniformly-flat with the printing surface facing outward,
without a loose or a distortion. Without a seam joint or a perforation because it makes a
paper jam.
4. Start of rolling
The start of the rolling must not be attached to the tube.
5. End of rolling
The end of the rolling is not specified, it must, however, be taped without a loose.
6. Rolling side
There must not be a scratch, a ruck, a dent, a deformation, or dirt on the rolling side.
7. End mark
A red end mark of 5 to 10 mm must be put at approx. 2 meters from the start of rolling on
the paper side.
8. Surface finishing
There must not be uneven coating, a dust, a pinhole, or a ruck. There must not be a scrap
which wears out the thermal head or degrades the printing.
THIS DOCUMENT CONTAINS CONFIDENTIAL INFORMATION, IS PROVIDED FOR FUJITSU CUSTOMER USE ONLY,
AND IS NOT TO BE SHARED WITH ANY THIRD PARTY WITHOUT FUJITSU'S PRIOR WRITTEN CONSENT.
Page 32