Advertisement
Quick Links
Safety Notice
The manufacturer is discharged from liability when damage
is caused by improper use or installation.
If any luminaire and/or accessory is subsequently modi-
fied, the persons responsible for the modification shall be
considered as manufacturer.
Product Information / Surge Protection
As an option, this luminaire can also be fitted with a surge
protector of Type 2-3 (at the time of order). The technical
data can be found directly on the installed device. If the
surge protector has been triggered by an adverse event,
the luminaire is automatically disconnected from the
mains. In that case, the LED on the surge protector no
longer lights up.
For comprehensive protection of the luminaire against
lightning and electrical surges, primary (Type 1) and
secondary (Type 2) surge arrestors must be installed into
the power supply. We recommend a combination arrestor
(Type 1+2+3), which is installed in the control cabinet.
WE-EF LIGHTING USA
Tel +1 724 742 0030
info.usa@we-ef.com
we-ef.com
The technical planner/installer is responsible for the pro-
per selection, sizing and installation of the surge protection
modules that must be provided on site. Please note the
various protection levels for Class I and II, as well as the
applicable statutory provisions regarding surge protection.
Installation and maintenance may only be performed by a
qualified electrician.
RLS400 LED_250522 / 006-1608
Technical specifications are subject to change.
© WE-EF 2022
WE-EF LIGHTING
Installation and
Maintenance Instructions for
Wall luminaires
surface mounted
RLS400 LED Series
Advertisement
Related Manuals for WE-EF RLS400 LED Series
Summary of Contents for WE-EF RLS400 LED Series
- Page 1 Installation and maintenance may only be performed by a surface mounted longer lights up. qualified electrician. RLS400 LED Series For comprehensive protection of the luminaire against lightning and electrical surges, primary (Type 1) and secondary (Type 2) surge arrestors must be installed into the power supply.
- Page 2 RLS420 ....6 LED 12W / 18W / 26W* ø 0.276 – 0.374 in max. 14 AWG * Nominal power, for latest data refer to (ø 0.354 – 0.472 in) www.we-ef.com Tools required – Screwdriver TX25...
- Page 3 4) Determine positions for two fixing screws E. Fixture is intended to be mounted over a UL listed Drill relevant holes F and insert nylon plugs G junction box (not supplied by WE-EF), use provided 1) Switch off the mains electrical supply. (not supplied by WE-EF).
- Page 4 5) Feed mains supply cable G (and second cable The pre-assembled cable entry J and packing ring I 7) Connect leads of main supply cable H (and H for through wiring, if required) through cable are suitable for cable diameters of 0.276 – 0.374 in. second cable I for through wiring, if required) entry J, while setting wall flange A in position.