WE-EF RMT320 LED Installation And Maintenance Instructions Manual
Street and area lighting luminaire
Hide thumbs
Also See for RMT320 LED:
Advertisement
Quick Links
WE-EF LEUCHTEN
Installation and Maintenance
Instructions
Street and Area Lighting Luminaire
RMT320 LED
Do not open during installation
This product is factory-sealed.
Refer to the instructions contained in this
document for details.
Surge Protection
This product features built-in surge protection circuitry in compliance with
applicable standards.
For comprehensive protection of a luminaire installation against lightning and
electrical surges, it is essential to cover mains supply and data input lines at
the distribution board level, by using respective primary (Type 1) and secondary
(Type 2) surge arrestors in compliance with EN61643-11/IEC61643-1.
Warning
Ensure that all required surge protection measures are in place and activated
prior to luminaire installation. Also, disconnect luminaires before operating
high-power devices such as, for example, electrical arc welders.
Advertisement
Related Manuals for WE-EF RMT320 LED
Summary of Contents for WE-EF RMT320 LED
- Page 1 WE-EF LEUCHTEN Installation and Maintenance Instructions Street and Area Lighting Luminaire RMT320 LED Do not open during installation This product is factory-sealed. Refer to the instructions contained in this document for details. Surge Protection This product features built-in surge protection circuitry in compliance with applicable standards.
- Page 2 Street and Area Lighting Luminaire RMT320 (or ø 60 x 80) IP66, IK09, Class I, ta = 40°C...
-
Page 3: Maintenance
Light Source Maintenance Apart from cleaning the product’s exterior surfaces, no special maintenance work is required. Do not use high- pressure cleaners. In case of component failure due to abnormal circumstances or at end of life, replacement must be carried out Warning: Do not open luminaire while mains supply is switched on. -
Page 4: Installation Procedure
Installation Installation Procedure The product must be installed and maintained by a 1) Switch off mains electrical supply. 2) Check that rating shown on luminaire label con- building/construction and/or electrical regulations and forms with mains electrical supply. relevant legislation. 3) Feed mains cable C into column G, while setting luminaire in position by following the orientation The supply cable must be installed inside the pole and indicators M. - Page 5 Installation to a pole Supply cable...
- Page 6 direction of light type of light distribution Circuit L1* Circuit L2* *only for version with two circuits...
- Page 7 WE-EF HELVETICA WE-EF LIGHTING Switzerland United States of America Tel +41 22 752 49 94 Tel +1 724 742 0030 Fax +41 22 752 49 74 Fax +1 724 742 0035 info.switzerland@we-ef.com info.usa@we-ef.com TO9202W0620 © WE-EF 2020 subject to change.
Need help?
Do you have a question about the RMT320 LED and is the answer not in the manual?
Questions and answers