Troubleshooting For Gas Burners (See Manufacturer's Instructions) - Roberts Gorden Combat POP-ECA 015 Installation, Commissioning, Operation & Service Manual

14.3 Troubleshooting for Gas Burners (see manufacturer's instructions)

START
Assuming fuel & electrical
supplies are ON.
Does the burner fan run?
Does the burner control
box 'lockout' before 10
seconds?
Does the burner control
box 'lockout' after 10
seconds?
Does the burner fire?
Does 'lockout' occur?
Does main gas fire?
Heater Operating
TROUBLESHOOT ENDS.
Is the pressure switch
No
(no contact open)
Fault lies elsewhere.
Yes
Use Section 14.4 to check
Yes
monitoring system.
No
Yes
pressure switches.
No
Check ignition circuit, fuel
No supply and gas solenoid
Yes
Use Section 14.4 to check
Yes
monitoring system.
No
Check main gas valves and
No
Yes
If problems persist, contact
ROBERTS GORDON
No
Tel: +44 (0)121 506 7709
Do not touch ignition components.
Voltage from ignition components is high.
Failure to follow these instructions can
result in death or electrical shock.
at rest?
No
Yes
the flame
Check combustion air fan is
Check settings
No
chamber is clean and sound.
sound. Check joint between
flue spigot and flue is sound.
valves.
the flame
wiring.
® at
www.rg-inc.com
SECTION 14: T
WARNING
Electrical Shock Hazard
See Section 10.5.1 for
setting.
clean. Check combustion
Check flue is clean and
ROUBLESHOOTING
47