Cch Wiring Diagram Gas Models 15-30 (Floor Standing) - Roberts Gorden Combat POP-ECA 015 Installation, Commissioning, Operation & Service Manual

COMBAT ® C H
ABINET EATERS
2. The control will then adjust the burner input
continuously to attempt to maintain the
temperature set on the control.
3. If the temperature continues to rise with the
burner operating at minimum fire, the control
will turn off the burner until the temperature falls
again, and the burner will restart.

9.3 CCH Wiring Diagram Gas Models 15-30 (floor standing)

PACKAGED
BURNER
Note: Remote fan control
carries full load of fan motor
7 amp inductive
TIME/TEMPERATURE
CONTROLS
FAN CONTROL
230 V 50 Hz
1 PH SUPPLY
NOTE:
Any of the original wire supplied with
the heater must be replaced with
wiring material having a temperature
rating of at least 105°C and 600 V.
20
I , C
NSTALLATION OMMISSIONING
GAS BURNER 7 WAY PLUG
4
3
Red / White
2
1
Red
L
1
L
2
L
3
Blue
N
MAIN TERMINALS
IN CONTROL PANEL
, O S
PERATION AND ERVICE
If a switch is required to turn on the main fan for
ventilation, this must be voltage free, from external
sources, and may be connected between terminals
L & 1 for models 015 to 030 and terminals 2 & 1 for
1
all other models.
Red / White
Red / White
10 A
Blue
M
ANUAL
Blue
FAN / LIMIT STAT
FAN
LIMIT
Brown
MAIN
FAN
MOTOR
1 mm2 Ø Red Tri Rated Flex Cable