Table of Contents
Advertisement
3.3.2
PROGRAMMABLE BAUD RATES
3.3.2 A
CONFIGURING PORT AS MODEM
16 15 14 13 12 11 10
H T T T T T ti
1
2
3
4
5
6
7
Figure 3-17
North Star HSIO-4
To configure an individual port for
synchronous operation with programmable
baud rates, make the following changes:
Please Note: When a port is configured for
synchronous operation, it must also be
configured to simulate either a MODEM or a
TERMINAL. (To determine whether your
particular application requires the MODEM or
TERMINAL configuration, consult Section
3.1.1.)
(PROGRAMMABLE BAUD RATES)
1.
Disconnect the link between pins 8 and 9
on the Configuration Header.
9
8
2.
Take an 8-pin shunt, disconnect the
link between pin 3 and pin 6, and install
it in the Clock Header socket.
3.
Refer to Section 3.3.3 for instructions on
programming baud rates for synchronous
operation.
m
8
7
6
5
Figure 3-18
41
User/Technical Manual
Advertisement
Table of Contents
