Table of Contents
Advertisement
North Star HSIO-4
Hold the board as shown in figure 2-5, with
the component side of the board toward the
front of the HORIZON. Slide the board into the
rear-most slot in the card cage. If that slot
is already occupied by another board, remove
that board and place it in an unused slot.
The row of metallic strips or "fingers" on the
bottom of the board should fit into the
connector at the base of the slot. Press
firmly on the top of the board to make sure it
is fully seated in the connector.
the HSIO-4 board should be even with the other
installed North Star boards.
If a second HSIO-4 board is utilized, it
should be installed in the slot immediately in
front of the first HSIO-4 board.
Figure 2-5
' 8
User/Technical Manual
The top of
Advertisement
Table of Contents
