NorthStar HSIO-4 User's & Technical Manual page 15

North Star HSIO-4
Before connecting the cables, you should
number each connector hole on the HORIZON back
panel. For use with the TSS/A, the connector
holes should be numbered as shown in Figure
2 - 8 .
From outside the back panel of the HORIZON,
thread each ribbon cable —
Mating Connector first —
hole. Gently pull the cable through until the
Terminal/Modem Mating Connector touches the
sides of the hole. From outside the back
panel, push firmly to seat the connector in
the hole.
Board Mating Connector
10
Figure 2-8
rectangular Board
through a connector
Terminal/Modem
Mating Connector
User/Technical Manual