Table of Contents
Advertisement
3.2.2
CONFIGURING PORT AS TERMINAL
North Star HSIO-4
If the HORIZON is to communicate with a modem
(or with another computer simulating a modem),
the interfacing HSIO-4 port must be configured
to simulate a terminal.
Configure an HSIO-4 port as a terminal as
follows:
1.
Carefully remove the shunt from the
Configuration Header socket and replace it
with a 16-pin header wired as follows:
pin
1 to pin
pin
3 to pin
pin
5 to pin
pin
7 to pin 10
pin
8 to pin
pin 11 to pin 12
pin 13 to pin 14
pin 15 to pin 16
2.
Remove the Clock Header (if there is
one present) from the Clock Header socket.
Please Note:
are not installed on the HSIO-4 board.
However, if a port has been configured for
synchronous operation, then a Clock Header
will have been installed and must now be
removed.
25
2
4
6
9
As supplied, Clock Headers
User/Technical Manual
Advertisement
Table of Contents
