Table of Contents
Advertisement
Shure T4 Diversity Receiver
Circuit
board
Reassembly
Antenna Replacement
Disassembly and Assembly
Antenna
É
É
É
É
Volume knob
Figure 3.
1. Slide the Volume knob back on: note how it is keyed to the flat part of the
shaft.
2. Rotate the antennas to their vertical positions. Place the pc board, com-
ponent-side up, inside the top half of the case: after feeding the anten-
nas through their holes, make sure the notches in the case align with the
Volume knob, the LEDs align with the holes in the upper half of the case,
and that the board is fully seated on the studs.
3. Swing the two halves of the case together until they snap in place.
4. Rotate the antennas until they lie flat against the case. Turn the receiver
upside down and secure the assembly with the four screws removed
earlier (Figure 2, page 7). Check that the Volume knob rotates freely.
The antennas can be replaced without disassembling the case. Rotate the
antenna you are replacing to its vertical position, collapse it, and remove the
mounting screw through its access hole in the bottom of the case (Figure 2). In-
sert the new antenna and start the screw from the bottom, leaving it loose
enough for you to rotate the entire antenna between your fingers. Rotate the an-
tenna in this way as you lightly press it into the case until you feel the base seat
in the slot of the bracket on the pc board. Tighten the screw.
Case top
8
Case bottom
Mounting screw
25C1020
(EA)
Advertisement
Table of Contents
