Advertisement
Advertisement
Table of Contents
Related Manuals for Shure PG2
Summary of Contents for Shure PG2
- Page 1 Performance Gear Series Wireless...
-
Page 2: System Components
English Shure Performance Gear Wireless Designed especially for performers who manage their own sound, Shure Performance Gear profes- sional audio products deliver legendary Shure sound quality, stage-proven durability and hassle- free setup for worry-free performance. Performance Gear Wireless systems are available in a variety of configurations - for handheld, guitar, headset and presentation applications. -
Page 3: Receiver Features
English PG4 Receiver Features Figure 1. Front Panel audio LED Channel Display Indicates strength of incoming audio signal: green for See “System Setup” on page 6. normal, amber for strong, red for peak. ... -
Page 4: Handheld Transmitter
Access the Gain Adjustment Switch by unscrewing the microphone head. Use the tip of a pen or a small screwdriver to move the switch. (See fig. 4) • The switch can be positioned in two gain settings on the PG2: Gain Setting Suggested Uses For quiet to normal vocal performance. -
Page 5: Wearing The Bodypack Transmitter
English PG1 Bodypack Transmitter 4-Pin Microphone Input Jack Power/Mute Button. Press and hold to turn on/off. Press and release to mute/unmute. Power/Mute LED (see LED Status below) Antenna Channel Display ... -
Page 6: System Setup
English System Setup Single Receiver Setup In any wireless setup, each transmitter and receiver pair must be tuned to the same frequency, or channel. Follow these steps to set the transmitter and receiver to the same channel: Plug in the receiver to turn power on. Turn transmitter power off. Press and hold the channel button on the receiver for about one second to enter select mode. - Page 7 English Multiple System Setup To set up multiple systems, repeat the previous steps for each transmitter and receiver pair. Once transmitters have been set, leave them on. Be sure to set each transmitter and receiver pair to a different frequency. For information about frequencies and compatibility, refer to the guide below. TLPW Frequency and Channel Guide In each group, channels 1,3,5,7 and 9 are a compatible set and channels 2,4,6,8 and 0 are a compatible set.
-
Page 8: Troubleshooting
Troubleshooting Issue LED Status Solution Transmitter Power/Mute • Perform transmitter setup (see page 6). No sound or faint LED on, receiver LEDs on • Verify all sound system connections. sound • Adjust transmitter gain. Receiver Channel Display • Make sure AC adapter is securely plugged into electrical outlet and into POWER connector on rear panel of receiver . -
Page 9: Specifications
75 grams (2.6 oz.) without battery Housing Molded poly carbonate case Power Requirements One 9V alkaline battery Battery Life >8 hours (alkaline) PG2 Handheld Audio Input Level +2 dBV maximum at –10dB position –8 dBV maximum at 0dB position Transmitter Gain Adjustment Range 10dB... -
Page 10: Replacement Parts
English Replacement Parts All Systems Microphone Stand Adapter (PGX2) WA371 System-Specific AC Adapter (120 VAC, 60 Hz) PS20 AC Adapter (230 VAC, 50/60 Hz, Europlug) PS20E AC Adapter (230 VAC, 50/60 Hz, UK) PS20UK AC Adapter (100 VAC, 50/60 Hz) PS20J AC Adapter (220 VAC, 50 Hz, China) PS20CHN... -
Page 11: Regulatory Information
Regulatory Information Regulatory Information for North America, Europe, and Australia PG1 & PG2 Transmitters: Certified to FCC Part 74 (FCC ID: “DD4PG1” and “DD4PG2”). Certified by IC in Canada under RSS-123 and RSS-102 (“IC: 616A-PG1” and “IC: 616A-PG2”). Meets the essential requirements of the European R&TTE Directive 99/5/EC (ETSI EN 300-422 Parts 1 &... - Page 12 United States, Canada, Latin America, Caribbean: 5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A. Phone: 847-600-2000 U.S. Fax: 847-600-1212 Int’l Fax: 847-600-6446 Europe, Middle East, Africa: Shure Europe GmbH, Phone: 49-7131-72140 Fax: 49-7131-721414 Asia, Pacifi c: Shure Asia Limited, Phone: 852-2893-4290 Fax: 852-2893-4055...
Need help?
Do you have a question about the PG2 and is the answer not in the manual?
Questions and answers
Will I have to use condenser button on my mixer desk with this system
No, you do not need to use the condenser button on your mixer desk with the Shure PG2 system. The PG2 system is a wireless microphone system with its own power supply, so it does not require phantom power typically used for condenser microphones.
This answer is automatically generated
@Mr. Anderson Hi - I'm sorry but I placed my question in the wrong dialogue box - I am using PG4 system - but thank you for your reponse