ICP DAS USA iSN-101 User Manual page 37

00290* Alarm status of open wire for iSN-101. Write 1 to clear latched alarm. R/W
00289 ~ Leak alarm status of leak sensor 0 to 3 for iSN-104. Write 1 to clear
00292 low latched alarm.
00293 ~ Open wire alarm status of leak sensor 0 to 3 for iSN-104. Write 1 to
00296 clear latched alarm.
00321 ~ Enable/disable leak alarm of leak sensor 0 to 3 (iSN-101:0)
00324
00322* Enable/disable alarm of open wire (for iSN-101 only)
00325 ~ Enable/disable open wire alarm of leak sensor 0 to 3
00328 (for iSN-104 only)
00337 ~ Leak alarm type, momentary or latched, of leak sensor 0 to 3
00340
(iSN-101:0)
00338* Alarm type, momentary or latched, of open wire (for iSN-101 only)
00341 ~ Open wire alarm type, momentary or latched, of leak sensor 0 to 3(for
00344 iSN-104 only)
00385 ~ Write 1 to clear high latched analog input value of sensor 0 to
00388 3(iSN-101:0)
00417 ~ Write 1 to clear low latched analog input value of sensor 0 to
00420 3(iSN-101:0)
* iSN-101 for firmware version A103 and later only
DIP Switch setting
1 Protocol
2 Configuration
3 Address
4 INIT mode
5 Sound
Base address: 96 (0x60)
iSN-101/104 User Manual
ON: DCON, OFF: Modbus RTU
ON: by software, OFF: by hardware
ON: added by 16, OFF: added by 0
ON: INIT, OFF: Normal
ON: turn on, OFF: turn off (for iSN-104 only)
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
W
W
- 37 -