Table of Contents
Advertisement
8. Click the Start Search icon.
9. The iSN-101/104 logger searched out will be listed as below.
10. Click the module name to configure the logger.
Note
The Protocol/Baud Rate/Parity/Checksum items marked with "(INIT*)" means that
when any of those items needs be modified, the pin 4.INIT needs to be set in ON
position and power cycle the logger, then the item can be modified. After complete
setting, set the pin 4.INIT back to OFF position and power cycle the logger again to
take the setting effect.
iSN-101/104 User Manual
- 22 -
Advertisement
Table of Contents
