Bang & Olufsen BeoPlay H5 - Headphones Manual

Box contains

The box contains Beoplay H5 wireless earphones, a charger, three cable clips, Silicone tips in four sizes and Comply tips in three sizes.

Tips fitting

Beoplay H5 contains Silicone tips and Comply tips with extra secure fit and a SweatGuard^TM membrane that prevents humidity and wax from entering the sound port. Beoplay H5 is fitted with medium Silicone tips out of the box. When using the Comply^TM foam tips, squeeze down the foam tip and roll the tip into a thin, round cylinder. Pull back and up on the ear into the canal.

Gently insert the entire tip into the ear. Hold the tip in place until it expands. See www.complyfoam.com for more information.

Earphone clip

The earphone clip can be attached to Beoplay H5 to shorten the cord to your preferred length.

Charging

Charge the earphones using the charger connected to a computer or the wall charger. The indicator flashes orange when charging, and turns solid green when it is fully charged.

Turn the earphones on

Short press the center button to turn on the earphones. The product indicator turns white, a sound is heard, and the product is ready for use.

Turn the earphones off

To turn off the earphones, connect the two magnetic ends of the earbuds. A sound is heard, and the indicator fades out. Beoplay H5 automatically turns off when inactive for over 15 minutes. Beoplay H5 can be worn around the neck by connecting the two earbuds.

Bluetooth pairing

Press and hold the center button for over 5 seconds to initiate Bluetooth pairing. Turn on Bluetooth on your device, and select Beoplay H5. The product indicator turns blue momentarily when successful. The indicator turns red momentarily if unsuccesful.

Beoplay H5 remembers previously connected devices. When turned on, Beoplay H5 attempts to reconnect to previously connected devices.

Remote control

The remote can be used for music and calls. Long press to activate voice recognition. During incoming calls, short press the center button to accept or long press to reject. During a call, long press to terminate and double press to transfer audio from Beoplay H5 to the device.

Battery indicator

When the indicator turns red, the battery is below 10%. When the indicator starts flashing red the battery is below 1%. In both cases a sound is heard. The battery level is also shown on the paired iOS devices next to the Bluetooth icon.

App

Beoplay

www.beoplay.com/app

Enrich your Beoplay H5 experience with the Beoplay app.

For more information, please visit www.beoplay.com/app.

If an error occurs, the product indicator on Beoplay H5 will flash red. To reset Beoplay H5 to factory settings, press and hold the volume up and volume down buttons for more than 5 seconds.

Update Beoplay H5 software using the Beoplay app. For more support visit http://www.beoplay.com/support/