Bang & Olufsen BeoPlay E6 - Headphones Manual

APP

beoplay.com/APP

Use the Beoplay app to personalize your listening experience, interact and update your product.

Package Contents

The box contains Beoplay E6 wireless earphones, a charger, two cable clips, four silicone Ear fins, Silicone tips in four sizes and Comply tips.

Tips

Charging

Charge the earphones using the charger connected to a computer or the wall charger. The indicator flashes orange when charging, and turns solid green when it is fully charged.

Turning earphones on

Short press the center button to turn on the earphones. The product indicator turns white, a sound is heard, and the product is ready for use.

Bluetooth pairing

Press and hold the center button for over 5 seconds to initiate Bluetooth pairing. Turn on Bluetooth on your device, and select Beoplay E6. The product indicator turns white momentarily when successful. The indicator turns red momentarily if unsuccesful.

Beoplay E6 remembers previously connected devices. When turned on, Beoplay E6 attempts to reconnect to previously connected devices.

Turning earphones off

To turn off the earphones, connect the two magnetic ends of the earbuds. A sound is heard, and the indicator fades out.

Beoplay E6 automatically turns off when inactive for over 15 minutes. Beoplay E6 can be worn around the neck by connecting the two earbuds.

Remote Control

The remote can be used for music and calls. Long press the center button until a sound is heard to activate voice recognition. During incoming calls, short press the center button to accept or long press to reject. During a call, long press to terminate and double press to transfer audio from Beoplay E6 to the device.

Battery Indicator

When the indicator turns red and a sound is heard, the battery is below 10%. Charge the battery using the charging unit. The battery level is also shown on the paired iOS devices next to the Bluetooth icon.

Tips Fitting

Beoplay E6 is fitted with medium Ear fins and medium Silicone tips out of the box. When using the Comply^TM foam tips, squeeze down the foam tip and roll the tip into a thin, round cylinder. Pull back and up on the ear into the canal.

Earphone clip

The earphone clip can be attached to Beoplay E6 to shorten the cord to your preferred length.

If an error occurs, the product indicator on Beoplay E6 will flash red. To reset Beoplay E6 to factory settings, press and hold the volume up and volume down buttons for more than 5 seconds.

Update Beoplay E6 software using the Beoplay app. For more support visit http://www.beoplay.com/support