Bang & Olufsen Beoplay H95 - Headphones Manual

DOWNLOAD BANG & OLUFSEN APP

Use the Bang & Olufsen app for setup, product customisation and music enhancing features.

TURN ON/OFF

Move switch to the ON position to turn on the headphones.
To turn off, move the switch to the OFF position. The headphones will automatically turn off when not in use for 15 mins.
Beoplay H95 remembers previously connected devices. When turned on, it will attempt to reconnect to previously paired devices.

Move switch to the top position and hold for 2 sec. to initiate Bluetooth pairing.
Release the switch when a sound is heard, and the indicator starts flashing blue.
Your Beoplay H95 is ready for pairing through the Bang & Olufsen App or in the Bluetooth settings on your device.

DAILY USE

Operate the headphones using the aluminium touch interface on the right earcup and the dials on each earcup.

ACTIVE NOISE CANCELLATION AND TRANSPARENCY

Rotate the dial on the left ear cup to adjust between Active Noise Cancellation and Transparency Mode. Rotate the dial towards your back to increase the level of noise cancelation until you hear a sound feedback. This suggests maximum noise cancelation is achieved

Rotate the dial towards your front to increase the level of transparency mode that will amplify your surroundings. Keep turning until you hear a sound feedback that suggests maximum transparency mode is achieved.

You can position the dial in the middle for neutral mode which is indicated by a sound feedback. This indicates both ANC and Transparency Mode off.

Beoplay H95 comes with Adaptive Active Noise Cancellation, which automatically adjusts to your surroundings

If you prefer to deactivative this feature, simply toggle it off in the Bang & Olufsen App.

CALLS

Use the touch alu disc on the right earcup to control calls.

STORE YOUR HEADPHONES

To store the headphones in the case, make sure that the sliders are fully pulled out, rotate the earcups to lay flat and fold the earcups towards the headband. There's room for mini jack cable, charging cable and flight adaptor inside the compartment in the carrying case.

CHARGING

You can charge the headphones using the USB-C cable which is included in the box.
You can still use your headphones while charging. It takes approximately 2 hours to fully charge Beoplay H95.
When the battery is fully charged, the indicator shows solid green.
When the battery power is below 10% the indicator turns red and a sound prompt is heard.

Documents / Resources

References

• ‎Bang & Olufsen on the App Store
• Google Play

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Bang & Olufsen Beoplay H95 - Headphones Manual