Continental Motors TSI0L-550-C Operation, Maintenance & Installation Manual page 144

Fuel System
Fuel Pump Replacement
The fuel pump can be replaced or it can be repaired
and calibrated in accordance with the applicable
instructions in the Fuel Injection System Parts And
Overhaul Manual, Form X30593A, latest revision.
NOTE...
Appropriate test calibration equipment must be
used when overhauling TCM fuel injection system
component.
Whenever the fuel pump is removed from the
engine, both the fuel pump drive coupling to
crankshaft gear clearance of 0.0095L to 0.0155L
1. Fuel pump drive coupling to crankshaft gear ............................................... clearance:
Fuel pump drive coupling to fuel pump ....................................................... clearance:
2.
9-14
SERVICE LIMITS
FIGURE 9-9. FUEL PUMP SERVICE LIMITS
and the fuel pump drive coupling to fuel pump
clearance 0.0030L to 0.0090L must be checked.
CAUTION...
When performing dimensional inspections, the
following Fits and Limits may be used. However,
they are intended only as a guide, when
performing engine maintenance prior to major
overhaul, in determining whether a part can be
reused. Parts which have dimensions or fits that
exceed service limits must not be reused. Parts
which have dimensions or fits up to and including
service limits may be reused. However, use sound
judgment and take into consideration the engine's
proximity to recommended overhaul.
0.0155L
0.0090L