Hyundai Santa Cruz Owner's Manual page 523

Emergency Situations
6. Loosen the wheel nuts
counterclockwise one turn each in
the order shown above, but do not
remove any wheel nuts until the tire
has been raised off of the ground.
7. Place the jack at the designated
jacking position under the frame
closest to the tire you are changing.
The jacking positions are plates
welded to the frame with two
notches. Never jack at any other
position or part of the vehicle. Doing
so may damage the side seal molding
or other parts of the vehicle.
8-18
ONX4OB081012 ONX4OB081012
8. Insert the jack handle into the jack
and turn it clockwise, raising the
vehicle until the tire just clears
the ground. This measurement is
approximately 1.2 inches (30 mm).
Before removing the wheellug nuts,
make sure the vehicle is stable and
that there is no chance for movement
or slippage.
9. Loosen the lug nuts with the wheel
lug nut wrench and remove them with
your fingers. Remove the wheel from
the studs and lay it flat on the ground
out of the way. Remove any dirt or
debris from the studs, mounting
surfaces and wheel.
ONX4OB081024 ONX4OB081024
Wheels may have sharp edges. Handle
them carefully to avoid possible severe
injury. Before putting the wheel into
place, be sure that there is nothing on
the hub or wheel (such as mud, tar,
gravel, etc.) that interferes with the
wheel from fitting solidly against the
hub.
If there is, remove it. If there is not
good contact on the mounting surface
ONX4OB081013 ONX4OB081013
between the wheel and hub, the wheel
nuts could come loose and cause the
loss of a wheel. Loss of a wheel may
result in loss of control of the vehicle.
This may cause serious injury or death.
WARNING
ONX4OB081014 ONX4OB081014