Table of Contents
Advertisement
Figure2-2 Mounting the router on a workbench
Mounting the router on a wall
1.
Mark two screw hole locations on the wall. Make sure the holes are level and the distance
between the two holes is 152 mm (5.98 in).
2.
Drill holes with a minimum depth of 22 mm (0.87 in) in the marked locations.
3.
Hammer an anchor into each hole until the anchor is flush with the wall.
4.
Drive a screw into each anchor and make sure the screw protrudes a minimum of 1.5 mm
(0.06 in) from the wall.
5.
Hang the router on the screws.
Position the router so the network interfaces face downwards, and the sides with ventilation
openings are perpendicular to the ground, as shown in Figure2-3.
2-3
Advertisement
Table of Contents
