Voice-Over Facility (Internal) - Panasonic AJ-D850 Operating Instructions Manual

Voice-over facility
Operating procedure 1
Microphone
1
2
3
4
5
6
7
8
9
10
11
12
<Note>
The audio signals can be previewed prior to editing by pressing the PREVIEW button while
the SET button is held down before the AUTO EDIT button is pressed.
(internal)
MIC
AMP
* Connect to the channel whose
sound is to be recorded.
Select INT_VO as the setup menu No. 322 (AUD MEM MODE) setting.
Select the same setting for the channel (CH1 or CH2) on which the sound is to be
recorded and for the setup menu No. 323 (AUD MEM CH) channel.
Insert the cassette tape for which the voice-over editing is to be performed.
Press the insert button for the channel (CH1 or CH2) on which the sound is to be
recorded and ensure that its lamp lights.
Press the PLAY button.
Search the position (IN point) where voice-over editing is to start while watching the TV
monitor.
Press the IN and SET buttons simultaneously at the IN point.
Input the audio signals to be recorded to the channel which was selected in step 2.
Search the position (OUT point) where voice-over editing is to end while watching the
TV monitor.
Press the OUT and SET buttons simultaneously at the OUT point. The audio signals to
be recorded are stored in the memory.
Press the STOP button.
Press the AUTO EDIT button to proceed with editing. The audio signals stored in the
memory are recorded from the memory onto the cassette tape.
ANALOGUE
AUDIO
IN*
– 43 –
VIDEO
OUT
TV monitor
AJ-D850A