Restore Default Values Mode - Epson TM-m50II Technical Reference Manual

3
After briefly pressing the Feed button (less than one second) for the number of times
shown in the print result, hold down the button for more than one second to select
the setting items.
The setting selected as the setting item, the current settings and initial settings are printed.
Depending on the setting item, you may need to continue selecting the setting item before the
settings are printed.
For details on setting items, see
4
Select a setting by briefly pressing the Feed button (less than one second) for the
number of times applicable to the setting, and then hold down the button for more
than one second to confirm your selection.
After saving the settings, the Software setting mode guidance is printed, and the Paper LED flashes.
5
To close Software setting mode, turn off the printer, or select "Exit" to return to Mode
selection guidance, and then select "Exit and Reboot Printer".
• To select 0 as the item number, hold down the Feed button until printing starts.
• If the button is pressed a number of times that is not displayed by the Setup guidance, the oper-
ation is invalid and the same guidance is printed.

Restore Default Values Mode

In Restore default values mode, following values saved on NV Memory will be set back to initial settings. When
any error occurs, you can use to specify the reason.
Setting Item
Customized Value
Memory switch
R/E (Receipt Enhancement) settings
USB Interface Settings
Network settings
TM-Intelligent function settings
NV graphics
NV bit image
User defined page
User NV memory
Follow the steps below.
1
After running a self test, hold down the Feed button for at least one second to enter
the Mode selection.
The Mode selection guidance is printed, and the Paper LED flashes.
"Software Settings" on page
Restore default settings
✔
✔
✔
✔
✔
✔
-
-
-
-
Chapter 3 Advanced Usage
50.
Restore default settings
and Delete definition data
✔
✔
✔
✔
✔
✔
✔
✔
✔
✔
67