Epson TM-m50II Technical Reference Manual page 40

Setup Procedure
Follow the steps below to set up the printer.
When shipped from the factory, the setting for obtaining an IP address is set to "Auto", so if there is a
DHCP server, the printer waits for an IP address to be assigned. If there is no DHCP server, a fixed IP
address (192.168.192.168) is set. In either case, the determined IP address will be printed
automatically.
1
Connect the computer and the printer to the same network.
2
Print the status sheet and check the current settings.
For instructions on how to print the status sheet, see
3
Change the network settings of the computer so that the network segment is the
same as the IP address of the printer you checked in step 2.
Subnet mask: Same subnet mask as the printer
IP address: Same segment as the printer (same network address), different host address
Example
Subnet mask
IP address
"Printing a Status Sheet" on page
Printer
255.255.255.0
192.168.192.168
Chapter 2 Setup
71.
Computer
255.255.255.0
192.168.192.2
40