3M PPS 2.0 Series Quick Start Manual

3M PPS 2.0 Series Quick Start Manual

Gravity performance spray gun
Hide thumbs Also See for PPS 2.0 Series:

Advertisement

Assembly

1
Attach the supplied air flow valve to the bottom of the gun.
2
Attach the nozzle to the spray gun with the locking collar fully connected. Note: It
is easier to install the nozzle while pulling the trigger backward toward the spray
gun handle. To remove the nozzle from the spray gun, reverse the process.
3
Attach 3M
PPS
Series 2.0 spray cup to nozzle. See back for directions.
4
Once the spray gun is properly assembled you may attach the air line.
For additional questions, contact your local 3M representative
or email: aadukenquiries@mmm.com.
See manual for additional use and health and safety information.
WARNING! Do not immerse spray gun or nozzles in cleaning solvents or gun washers.
*Operating Pressure Range (OPR) is the inlet pressure range for safe function of the spray gun.
3M
Performance Spray Gun – Gravity
Operating Pressure Range* is between 7 psi - 37 psi (0.5 bar - 2.6 bar)

Recommended set up starting points

Fan control knob: Open 1.5 turns for HVLP nozzles, 2.5 turns for Fine Finish
nozzles from closed position
Fluid control knob: Open 4 rotations from closed position
See recommended pressure setting on Atomising Head Air Cap.

Nozzle recommendation

* Starting points only, refer to Paint Manufacture for recommendation
on fluid tip size.
2.0
High viscosity coatings
Sprayable fillers
High build primer
Primer surfacer
Wet on wet primer
Primer sealer
Direct gloss
Single stage top coat
Solvent base colour
Clearcoat
Waterborne base coat
UV Primers
Midcoat / Effect Coats
Smart / Spot repair
1.8
1.6
1.4
1.3
1.2
0.9

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PPS 2.0 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for 3M PPS 2.0 Series

  • Page 1 Once the spray gun is properly assembled you may attach the air line. Solvent base colour • • Clearcoat • • • For additional questions, contact your local 3M representative Waterborne base coat • • or email: aadukenquiries@mmm.com. UV Primers • •...
  • Page 2 ™ Spray Cup System cup. For additional questions, contact your local 3M representative or email: aadukenquiries@mmm.com. See manual for additional use and health and safety information. © 3M 2022. 3M and PPS are trademarks of 3M Company. All rights reserved.

Table of Contents