Table of Contents
Advertisement
Rear Module Options
RM20-9251-A
The rear modules shown below provides the input/output connections shown. Split rear
modules (/S) provide connections for two cards in adjacent slots using one rear module.
RM20-9251-B/S is available in HD-BNC and DIN1.0/2.3 versions.
Note: The RM20-9251-A/S and RM20-9251-B/S rear modules are usable only with the 20-slot frame.
RM20-9251-A rear module available for 8310-series (10-slot frame) as part number RM-9251-A.
Figure 3. Rear Modules
Board Installation
Use the following procedure to install the 9251 in the frame.
1. Refer to the User Manual of the frame to ensure that the frame is properly
installed according to instructions.
2. After selecting the desired frame installation slot, hold the 9251 card by the
edges and carefully align the card edges with the slots in the frame. Then
fully insert the card into the frame until the rear connection plugs are properly
seated on the midplane and rear module.
This completes the procedure for installing the 9251 in the frame.
RM20-9251-A/S
10
RM20-9251-B/S
Advertisement
Table of Contents
