Table of Contents
Advertisement
User Controls
This chapter contains a description of the 9251 user controls:
.
User Controls
No Lock LED
COM Activity LED
Figure 3. Card-edge User Controls
EQ Switch — SW1
The EQ Switch (SW1) is used to insert the cable equalizer into the incoming AES/EBU signal. The
9251 can recover digital audio signals conforming to AES/EBU specifications and transmitted over
75ohm, coaxial cable, up to 600 metres (2000 ft) long without equalization. For cable lengths in
excess of 600 metres, we recommend that the input equalization be activated. Note that switching the
EQ in and out can cause audible artefacts.
•
EQ Switch
•
LEDs
Lock LED
EQ LED
Error LED
•
Pressing the EQ Switch SW1 will activate the yellow EQ LED to indicate this
feature is activated.
•
While the EQ Switch SW1 is activated pressing it again will disable the EQ and
the yellow EQ LED will go off.
EQ Switch
11
Advertisement
Table of Contents
