Table of Contents
Advertisement
Important Regulatory and Safety Notices
Before using this product and any associated equipment, refer to the "Important Safety
Instructions" listed below so as to avoid personnel injury and to prevent product damage.
Products may require specific equipment, and /or installation procedures be carried out to satisfy
certain regulatory compliance requirements. Notices have been included in this publication to call
attention to these Specific requirements.
Symbol Meanings
Warning
Caution
Notice
ESD
Susceptibility
Important Safety Instructions
Caution
Warning
Warning
This symbol on the equipment refers you to important operating and
maintenance
(servicing)
Documentation. Failure to heed this information may present a major risk of
damage or injury to persons or equipment.
The symbol with the word "Warning" within the equipment manual indicates
a potentially hazardous situation, which if not avoided, could result in death or
serious injury.
The symbol with the word "Caution" within the equipment manual indicates a
potentially hazardous situation, which if not avoided, may result in minor or
moderate injury. It may also be used to alert against unsafe practices.
The symbol with the word "Notice" within the equipment manual indicates a
situation, which if not avoided, may result in major or minor equipment
damage or a situation which could place the equipment in a non-compliant
operating state.
This symbol is used to alert the user that an electrical or electronic device or
assembly is susceptible to damage from an ESD event.
This product is intended to be a component product of the openGear® 8000
series frame. Refer to the openGear 8000 series frame User Manual for
important safety instructions regarding the proper installation and safe
operation of the frame as well as it's component products.
Certain parts of this equipment namely the power supply area still present a
safety hazard, with the power switch in the OFF position. To avoid electrical
shock, disconnect all A/C power cords from the chassis' rear appliance
connectors before servicing this area.
Service barriers within this product are intended to protect the operator and
service personnel from hazardous voltages. For continued safety, replace all
barriers after any servicing.
This product contains safety critical parts, which if incorrectly replaced may
present a risk of fire or electrical shock. Components contained within the
product's power supplies and power supply area, are not intended to be
customer serviced and should be returned to the factory for repair.
To reduce the risk of fire, replacement fuses must be the same type and
rating.
Only use attachments/accessories specified by the manufacturer.
instructions
within
3
the
Product
Manual
Advertisement
Table of Contents
