Major Operating Controls And Their Functions; Front View - Panasonic WJ-HD500A Operating Instructions Manual

MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS

Front View

e
w
q
q Operate Indicator (OPERATE)
Is on when the power of the WJ-HD500A Digital Disk
Recorder is turned on.
w Timer Indicator (TIMER)
Lights to indicate when the TIMER is set to INT (internal
timer) in the setup menu.
e Remote Indicator (REMOTE)
Lights to indicate when the Disk Recorder is controlled
by an outboard device via the Serial or 10/100BASE-T
port on the rear of the Disk Recorder.
r Alarm Suspend Indicator (ALARM SUSPEND)
Lights to indicate that the alarm suspension mode is
selected.
t Alarm Reset Button (ALARM RESET)
This button cancels an activated alarm.
Pressing this button will reset the alarm and return the
system to the condition before the alarm function was
activated.
y Alarm Indicator (ALARM)
This indicator blinks to indicate that an alarm condition
exists.
It changes to a steady light when the alarm is reset
automatically.
To turn the indicator off, press the ALARM RESET but-
ton.
u Sequence Button (SEQUENCE)
Runs the assigned sequence on the selected monitor
screen for the specified duration.
During the sequence, pressing this button will pause
the sequence that is being run on the monitor screen.
6
t y u !0
r i o
LOCK
1 2
REMOTE
ALARM
SPOT
ALARM
MULTISCREEN
5 6
RESET
TIMER
MULTISCREEN
ALARM SELECT
9 10
SUSPEND
HDD
OPERATE
SEQUENCE
13 14
FULL
#1 #0
!1 !2 !3 !4 !5 !6
GROUP
SELECT
REC STOP
3 4
SET
INDEX
REC PREVIEW
7 8
ALARM SEARCH
EL-ZOOM
11 12
SETUP
DISPLAY
/ESC COPY
15 16
DAYLIGHT SAVINGS
@9 @8 @7 @6 @5 @4
The LED indicates the status as follows.
On: Sequence is being run.
Blinking: Sequence is in pause mode.
i Multiscreen Selection Button
(MULTISCREEN SELECT)
Selects the multiscreen pattern to be displayed on the
Multiscreen Monitor that is connected to the MULTI
SCREEN OUT on the rear of the Recorder.
Pressing this button will toggle the display on the moni-
tor screen as shown below.
4 7
o Monitor Selection Button (SPOT/MULTISCREEN)
Selects to control the display on the screen for either
the Spot or Multiscreen Monitor.
Pressing this button will toggle the indicator in the but-
ton on and off to indicate the selected monitor as shown
below.
On: Indicates the Spot monitor is selected.
Off: Indicates the Multiscreen monitor is selected.
!0 Lock Button (LOCK)
Toggles to enable or disable the button lock function on
both front panels of the Disk Recorder and Remote
Controller.
The LED indicates the status as shown below.
On: The button lock is enabled.
Off: The button lock is disabled.
While On, the button lock will be released only if the
preset password is entered in the password inquiry win-
dow.
!7 !8 !9 @0
BPLAY/ PAUSE
STOP REC
REV FWD
WJ-HD
@3 @2 @1
9 10 13 16 4 screen segments
FS 16
Digital Disk
Recorder
A