Connection With The Extension Unit; Connection With The Dvd Extension Unit - Panasonic WJ-HD500A Operating Instructions Manual

Connection with the DVD Extension Unit

The WJ-HD500A Digital Disk Recorder controls the WJ-
HDE510 DVD Extension Unit through the SCSI chain.
<Connection with the DVD Extension Unit
without HDD>
The figure shows a WJ-HDE510 without an HDD.
The DVD-RAM is used for backup of the data recorded
on the WJ-HD500A Digital Disk Recorder.
1. Connect between the COPY port on the WJ-HD500A
and the COPY IN port on the 1st DVD Extension Unit
with the supplied (WJ-HDE510) SCSI cable.
Plug the cable end with magnetic core into the COPY
port, and the other ends into the COPY IN port.
2. Connect between the EXT STORAGE port on the WJ-
HD500A and the EXT IN port on the 2nd Extension
Unit with the supplied (WJ-HDE510) SCSI cable.
Plug the cable end with magnetic core into the EXT
STORAGE port, and the other ends into the EXT IN
port.
The system can be expanded by up to 6 Extension
Units.
To connect the other Extension Units, refer to the
operating instructions of each unit for further informa-
tion.
Switch Settings
1. Set MODE switch #2 on the rear of the WJ-HD500A to
OFF when connecting a DVD Extension Unit without an
optional HDD.
Set the MODE switch to ON if other Extension Units are
installed in the system.
2. Set the SCSI ID and TERMINATION of the Extension
Units as required.
22
Digital Disk Recorder
WJ-HD500A
SCSI ID=6 and 7
EXT
STORAGE
IN EXT STORAGE
SPOT
OUT
OUT
MULTI SCREEN OUT AUDIO CONTROL
16 15 14 13 12
IN
OUT
16 15 14 13 12
CONTROL port
SCSI cable
(supplied with
Extension Unit)
COPY IN
EXT IN
EXT OUT
HDD
INSTALLED
NOT INSTALLED
EXT IN
EXT IN
EXT OUT
Extension Unit #2
WJ-HDE500/HDE505
SCSI ID=0 to 5
ON
COPY port
GEN-LOCK OUT
COPY
SIGNAL GND
REMOTE(WV-CU50)
DATA 10/100
BASE-T
SERIAL
ALARM MODE
11 10 9 8 7 6 5 4 3 2 1
11 10 9 8 7 6 5 4 3 2 1
VIDEO
SCSI cable (supplied)
DVD Extension Unit #1
WJ-HDE510
SCSI ID= not set
COPY IN
AC IN
G
THERMAL ERROR OUT
SCSI ID NC
-
TERMINATOR
1
+ ON
OFF
Terminal board
AC IN
SCSI ID
–
TERMINATOR
+ ON
OFF
1 2 3 4
MODE
AC
IN
ON
OFF
POWER
POWER
ON
OFF
SIGNAL GND
POWER
ON
OFF
SIGNAL GND